Used Boats: 78 Adverts Displaying: 11-20
Detroit 6-71 Natural Marine Diesel Engine
Price: $3,000 USD
Runs fine
Removed from a workboat
Located in: New York State...
read more
1954/2010 70' x 19.5' x 9' Ex US Army ST Class Harbor Tug
Overall length: 70'11"
Gross tonnage: 72 tons
Net tonnage: 57
Last survey: October 2010
Shell plate thickness: 5/16"
Headroom in wheelhouse, cabin and engine room: 7'
Engine: CAT D398 - S/N 35Z1141, Arr # 5N72, 850 hp, year 1982, low hours
Engine was totally rebuilt in 2004 and purchased by owner in 2008.
Transmission: Twin Disc MG540 4.10:1 ratio - 100 hrs since rebuilt
Shaft size: 8"
Propeller: 6' x 5', 4 blade, RH, bronze
Coolers: Two Fe...
read more
Year: | 1954 |
Length: | 70' 11" |
Location: | Massachusetts USA |
Price: | $675,000 |
View Details |
Huge Folding Stock Anchor Circa 1830
Price: $11,000 USD
Statement piece!
This anchor dates to 1830 – 1860
This behemoth was pulled from the Atlantic by a Chincoteague shrimp boat. It was found in the vicinity of the Juno wreck, although it’s not quite old enough to have been from the Juno.
Like most of these old beasts, it came up without it’s stock. Replacement was fabbed from 4″ hot rolled steel pipe.
The shank measures 10′ 6″ long and it is 76″ across the flukes. Has a 9′ stock and weighs 2500 pounds.
It has been professionall...
read more
8" Electric Powered Booster Pump with Direct Feed Tank
200 hp electric motor with 15hp service water pump
Dredge pump is belt driven
Service water with soft start panel
Skid mounted
Just serviced and ready to go
Located in Florida
New price: $36,000 USD
Reference No. D2110...
read more
2013 40′ x 14′ Steel Spud Barge w/Crane (Sides Fold for Trucking!)
Price: $65,000 USD
The fold-up sides on this handy crane barge make it truckable
Shell plate thickness 1/4″
Powered by 2 Mercury 150hp outboards (2013)
1 hatch, 3 bulkheads
Spuds are 6" x 6", 20' long
Gas powered hydraulic power pack powers knuckle boom crane, spuds and raise and lower the outboards
Crane has 3/8″ cable and at 37′ will pick 4,000 lb
Hydraulic steering
Location: Western Michigan...
read more
Year: | 2013 |
Length: | 40' |
Location: | Michigan USA |
Price: | $65,000 |
View Details |
Walter Keel Coolers – 2 sizes available
3 are from 6-71 Detroit Diesels $3,500 USD each
2 are from 12-71 Detroit Diesels $5,000 USD each
Location: New York State...
read more
G2301
PICTURE COMING SOON
(2) 6-71 3 Phase Gensets
•Price: $5,000 USD each
•Powered by 6-71
•Removed from a tug
•Located in South Carolina...
read more
Detroit Diesel 6-71 T Engine
Price: $2,500 USD
Right hand
Good runner
Bypass blower
SAE #1 bell housing
Located in: New York State...
read more
R-L 84.5 X 77.25 4-Blade 7.5” Bore Propellers
S.E.Bore: 6” (3/4” to Foot)
BW: 20.75” HL:17”
Avondale Troost Propeller
Location: Louisiana
Price: On Request...
read more
R-L 94 X 66.5 4 Blade 9” Bore S/S Avondale ABS
B/W: 33 – H/L: 16.75” Hub Dia: 15” Like New
S.E.Bore: 6 11/16”
Location: Louisiana
Price: On Request...
read more